Fisher & Paykel ACTIVESMART RS80 Installation Manual page 27

IMPORTANT!
Ice and Water display
(Ice and Water models
Failure to follow these steps can lead to difficulties in door panel adjustment and cosmetic cap fitment.
●
only)
For water dispensing door panels: Remove the protective film from the appliance doors before hanging door panels.
●
Connect the external display module
(for Water dispensing model only)
External display module
(1)
Locate the external display
1
module from inside the appliance.
Thread the display harness
2
through the door panel cavity (A).
– Ensure the grommet
Turn the top display tabs at an
3
angle into the door panel (B).
– Ensure the harness is free
Push firmly against the bottom
4
display tabs and insert into
the door panel until you feel
it clip securely.
– Ensure the display is flush
Remove water tube
5
from the holder on
the appliance door
(C).
Hang the door panel
6
onto M8 studs.
– Ensure the
!8 DOOR PANEL INSTALLATION — STAINLESS STEEL
is engaged.
of pinching.
with the door panel.
C
panel is free to
pivot for water
connections.
Connect the display harness onto the
7
appliance door by inserting firmly until you feel
A
it clip securely (D).
– On the external display, enable the
dispenser lock to
prevent any water
from dispensing
during water
connection.
– To lock, press the
button for 4 seconds.
The LED above the
B
button will illuminate.
Enable the dispenser lock to prevent any water
8
from dispensing during water connection. To lock,
press the button for 4 seconds. The LED above
the button will illuminate.
Push the water tube firmly
9
into the spigot behind
the door panel until
the marked line is not
visible (E).
– Ensure the water
tube is routed away
from any sharp
objects or corners,
and not in a location
where it can be
kinked or squashed
when the door panel
is secured, (as this
will stop water flow).
D
E
25