Advertisement
Lab 2: Make Current – Voltage (I – V) Sweep Measurement to get
LED I – V Characteristics
Find us at www.keysight.com
d. Press
, and then press
(1) Press More...
e. Press
, then press
After turning on Single Linear Sweep Mode, you can see Source
Shape which shows the single linear sweep mode.
(1) Press
and then press LINEAR SINGLE
f. Rotate
to select Channel 1 Sweep Parameters and set them up as
below. (Start: 0 V, Stop: 2 V, Points: 101, Step: 20 mV)
3. Change View mode to Graph View
a. Press
repeatedly until Graph View is
shown in the display.
to show Sweep Sub-Panel.
(2) Press Show Sweep
to turn on Single Linear Sweep Mode.
Source Shape
Page 8
Advertisement
