Instructions For Use; Error Message On The Display - Flex ADM 60 Operating Instructions Manual

Instructions for use

WARNING!
– Do not point the laser beam at people or
animals.
– Do not look into the laser beam.
– Do not put any optical instruments in the
path of the beam.
This measuring instrument generates laser
radiation which may cause blindness.
CAUTION!
– Do not use the measuring instrument
in a damp, dusty or sandy environment.
Device components may be damaged.
– If the device is brought from a very cold
to a warmer environment or vice versa,
you should allow the device to acclimatise
before using it.
– If using adapters and tripods, ensure that
the device is screwed on tightly.
The most important operating steps are
explained at the end of these instructions
on the illustrated pages.
See from page 166.
Inserting/changing batteries ................... 166
Switching the device on and off ............. 168
Setting unit of measurement .................. 170
Selecting reference point ....................... 172
Setting measuring mode ........................ 174
Linear measurement .............................. 176
Area measurement ................................ 178
Volume measurement ............................ 182
Single Pythagorean ............................... 186
Double Pythagorean .............................. 190
Continuous measurement ...................... 194
Maximum/minimum measurement ......... 196
Addition and subtraction ........................ 198
Checking precision ................................ 202

Error message on the display

Error code Cause
➜ Remedy
001 The reflected laser beam is too intense.
➜ Do not aim at highly reflective surfaces;
if required cover (e.g. with paper).
002 Measurement range exceeded.
➜ Take measurements within the range
of 0.1 to 60 m only.
FLEX ADM 60
15