Mercedes-Benz G-Class 2020 Operator's Manual page 410

408 Wheels and tires
Attach wheel wrench 3 to socket
#
tighten the hub cap clockwise.
Specified tightening torque: 20 lb-ft
(27 Nm).
Raising the vehicle when changing a wheel
Requirements:
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
R
change ( page 406).
/
The hub caps have been removed
R
( page 407).
/
2 and Installing the jack
Assemble pump lever 1.
#
Place pump lever
#
ering screw 2 on the jack.
Turn pump lever 1
#
go.
Lowering screw 2
3
Adapter
To raise the vehicle at the front: adapter
must be secured on the jack.
To raise the vehicle at the rear: remove
adapter
Important notes on using the jack:
Only use the vehicle-specific jack that has
R
1 with the recess on low‐
been tested and approved by Mercedes-Benz
to raise the vehicle.
clockwise as far as it will
The jack is only designed for raising and
R
holding the vehicle for a short time while a
is closed.
wheel is being changed and not for mainte‐
nance work under the vehicle.
3 from the jack.
3