Mercedes-Benz G-Class 2020 Operator's Manual page 138

136 Driving and parking
* NOTE Damage to the drivetrain and
engine when pulling away
Do not warm up the engine while the
#
vehicle is stationary. Pull away immedi‐
ately.
Avoid high engine speeds and driving at
#
full throttle until the engine has reached
its operating temperature.
* NOTE Damage to the catalytic converter
due to non-combusted fuel
The engine is not running smoothly and is
misfiring.
Non-combusted fuel may get into the cata‐
lytic converter.
Only depress the accelerator pedal
#
slightly.
Have the cause rectified immediately at
#
a qualified specialist workshop.
Limited braking effect on salt-treated roads:
Due to salt build-up on the brake discs and
R
brakepads, the braking distance can increase
considerably or result in braking only on one
side
Maintain a much greater safe distance to the
R
vehicle in front
To prevent salt build-up:
Brake occasionally while paying attention to
R
the traffic conditions
Carefully depress the brake pedal at the end
R
of the journey and when starting the next
journey
Notes on off-road driving
& WARNING Risk of accident if you do not
keep to line of fall on inclines
If you drive at an angle or turn on an incline,
the vehicle could slip sideways, tip and roll‐
over.
Always drive on inclines in the line of
#
fall (straight up or down) and do not
turn.
& WARNING Risk of fire due to flammable
materials on hot parts of the exhaust
system
Flammable material such as leaves, grass or
twigs may ignite if they come into contact
with hot parts of the exhaust system.
When driving on unpaved roads or off-
#
road, regularly check the vehicle under‐
side.
Remove trapped plants or other flam‐
#
mable material.
If there is damage, consult a qualified
#
specialist workshop immediately.
When driving off-road, substances such as sand,
mud and water or water mixed with oil may get
into the brakes. This may lead to a reduction in
braking effect or total brake failure as a result of
increased wear. The braking characteristics will
vary depending on the material that has entered