Mercedes-Benz G-Class 2020 Operator's Manual page 409

The required tire-change tool is available. If
R
your vehicle is not equipped with the tire-
change tool kit, consult a qualified specialist
workshop to find out about suitable tools.
The vehicle is not on a slope.
R
The vehicle is on solid, non-slippery and level
R
ground.
Apply the electric parking brake manually.
#
Move the front wheels to the straight-ahead
#
position.
Shift the transmission to position j.
#
Switch off the engine.
#
Make sure that the engine cannot be started.
#
Place chocks or other suitable items under
#
the front and rear of the wheel that is diago‐
nally opposite the wheel you wish to change.
Remove the hub caps if necessary
#
( page 407).
/
Raise the vehicle ( page 408).
/
#
Removing and installing hub caps
Requirements:
The vehicle is prepared for a wheel change
R
( page 406).
/
Plastic hub cap
To remove: turn the center cover of the hub
#
cap counter-clockwise and remove the hub
cap.
To install: make sure that the center cover
#
of the hub cap is turned counter-clockwise.
Position the hub cap and turn the center
#
cover clockwise until the hub cap engages
physically and audibly.
Wheels and tires 407
Aluminum hub cap
To remove: position socket 2
#
1.
%
The socket can be found in the tire-change
tool kit.
Position wheel wrench 3 on socket 2.
#
Using wheel wrench 3, turn hub cap
#
counter-clockwise and remove it.
To install: position hub cap 1
#
it is completely flush with the wheel.
Position socket 2 on hub cap 1.
#
on hub cap
1
and turn until