Table of Contents
Advertisement
FREE MIXER:
RX FREE MIXER
MIXER:
MASTER CH:
SLAVE CH:
TRIM:
TRAVEL -:
TRAVEL+:
Parameter
MIXER
MASTER CH
SLAVE CH
TRIM
TRAVEL-
TRAVEL+
MIXER: Up to fi ve mixers can be programmed simultaneously. Switch between Mixer 1, Mixer 2,... and Mixer
5 through „MIXER".
The following settings in this display always for just the mixer selected in the „MIXER" line.
MASTER CH („from"): the signal applied at the MASTER CH (signal source or source channel) is mixed to
a variable extent to the SLAVE CH (target channel). According to the same principles described in the section
„Free mixer" of the HoTT transmitters.
SLAVE CH („to"): The signal of the MASTER CH (source channel) is mixed proportionally to the SLAVE CH
(target channel). The degree of mixture is determined by the percentages entered in the lines „TRAVEL–" and
„TRAVEL +". Select „00" if no mixer should be set.
TRAVEL–/+ (proportion of the admix in %): With the settings of these two lines the percentage of the admix
is specifi ed in relation to the MASTER signal separately for each direction.
4. FIRMWARE UPDATE GR-12SH+/SC+ RECEIVER
Firmware updates for the receiver can be transferred via the socket „T" in conjunction with a PC running Win-
dows XP, Vista or 7. For this you also require the USB interface, Order No. 7168.6, and the adapter leads Order
No. 7168.S and Order No. 23048 (for 33566), which are available separately.
The program „micro software loader" and fi les required for this are available from www.graupner.de in the
Download area for the corresponding products.
Caution: disconnect all servos from the receiver before carrying out an update, as they could run un-
controllably to one end-point during the procedure, and possibly cause damage to the model.
Manual Graupner HoTT 2.4
Important notice:
<
If you have already programmed mixer functions in the „Wing mixer"
1
or „Free mixer" menu, make absolutely sure that these mixers do not
overlap with those in this menu!
1
2
+0%
+100%
+100%
Description
Mixer selection
Signal source or source channel
Target channel
Trim position in %
Admix negative
Admix positive
Setup
1, 2....5
0,1,2,...6
0,1,2,...6
-15 - + 15%
0 - 150%
0 - 150%
04
Advertisement
Table of Contents
