Graco Ultra-lite A Series Instructions-Parts List Manual page 12

Pistol grip flo-gun waterbase compatible
Table of Contents

Advertisement

Complete Disassembly and Assembly
of the Gun (continued)
Assembly
1. Follow steps 9 to 11 on page 10.
2. Lubricate the o-rings (5 and 6) and install them into
the gun body.
3. Follow steps 12 to 14 on page 10.
4. Lubricate the trigger pivot holes (a) bracket guide
(b), and rod (13).
5. Install the trigger (29) with the rod (13) and retain-
ing rings (8).
6. Lubricate the thread and o-ring sealing surface on
the valve seat nut (26). Torque the valve seat nut
into the gun body (17) to:
Models 235–627, 237–607, and 237–649: 70–80
in-lbs (7.9–9.0 N m).
Model 235–628: 100–125 in-lbs (11.3–14.1 N m).
7. Lubricate the trigger lock housing area (c) and ap-
ply low strength anaerobic sealant to the screws
(9). See Fig. 5.
8. Install the spring (7) into the gun body (17). Place
the ball (2) in the center of the spring.
9. Align the trigger lock detent (d) with the ball (2).
Compress the ball (2) and spring (7) with the trig-
ger lock (15) until the trigger lock is seated in the
housing.
10. While holding the trigger lock (15) in place, install
the gun handle (14). Secure the gun handle with
the screws (9). Torque the screws to 6–10 in-lbs
(7.9–9.0 N m).
11. For model 237–649, if the inlet fitting (19) and fluid
tube (18) were disassembled, apply pipe thread
sealant compount to the inlet fitting (19). Install the
inlet fitting into the fluid tube (18). Torque the fitting
to 110–130 in-lbs (12.4–14.7 N m).
Service
12. Install the fluid tube (19) through the gun handle
(14) and screw it into the gun body (17). Torque
the fluid tube (19) to:
Models 235–627, 237–607, and 237–649: 50–60
in-lbs (5.6–6.8 N m).
Model 235–628: 200–250 in-lbs (22.6–28.2 N m).
To avoid loosening the connections and damaging
the gun, grip the gun body (17), not the handle (14),
when tightening the fluid tube (19).
13. Adjust the free travel of the trigger as instructed
under Adjusting the Valve, page 9.
14. Follow steps 15 to 19 on page 10 to finish assem-
bling the gun.
F
17
c
NOTES:
A
Torque to 6–10 in-lbs (0.68–1.13 N m)
F
Apply lithium base grease
M
Apply low strength anaerobic sealant (blue)
Fig. 5
CAUTION
9
A
F
7 2 15
d
c
M
14

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents