Data-Tronix DT-HDIPCOM Installation & Configuration Manual page 28

Step 5: Uncheck 'Enable HTTP' and Select Protocol UDP Unicasting
Step 6: Enter Destination IP of the COM2000 QAM.
Step 7: Enter Destination Port of the QAM Channel.
Step 8: Click 'Add'.
Step 9: 'Save and Confirm' all changes.
Step 10: Select Network Setup.
Step 11: Uncheck 'Enable DHCP' to set Static IP address.
Step 12: Enter an IP address in the same IP scheme as the COM2000 system.
Step 13: Enter Subnet Mask.
Step 14: Enter Default Gateway (if required).
Step 15: Set NTP Server (if required).
Step 16: Select Time Zone (as required).
Step 17: ***Save and Confirm*** all changes on Network page.
Note: Installer will lose connectivity after changing the IP address and saving the new settings.
Remember to set the PC in the same IP Scheme as newly configured IP address of the device.
The SOAP Port of the device is used as part of the IP address entered into the browser to manage the device
(192.168.3.3:8888)
Step 18: Once all the settings are made- connect an Ethernet cable from the Streamer to the 1Gbe or 2Gbe port on
the COM360.
Step 19: Continue setting up COM2000 as usual.
Note: We highly recommended backing up your config files for the streamer. See Administration Tab for Backup and
Restore Functions.
For more detailed step by step instructions see:
http://www.technicolor.com/en/solutions-services/connected-home/commercial-video-solutions/library
See: Inserting HD/SD Local Content with the COM2000 System
NACE: 610-429-1511 | sales@datatronix.biz | www.datatronix.biz | DT-HDIPCOM Manual v1.0 Page 28