Fire Sense Lux Series Manual page 6

ASSEMBlY
3
Attach the Post F to the Post Supports
base of the Post with the holes on the tops of the Post Supports,
then place a Washer HH on a Bolt CC and insert through the
aligned holes. Slide another Washer HH onto the bottom of the
Bolt and secure with a Nut DD. Repeat this process in the 5
remaining holes (6 holes total—2 per Post Support). Hand-tighten
initially, then fully tighten using wrenches once all hardware is
placed.
Now tighten the Bolts holding the Post Supports
using a wrench.
Hardware Used:
4
Slide Tank Housing C
to rest on Base I.
5
Attach Head Assembly
NOTE: there is a small piece of protective foam located in
the neck of the Head Assembly that MUST be removed
prior to attaching Head Assembly to Post. Route Gas Hose
D down into Post and align 4 small holes on Head Assembly
with 4 small holes in Post.
HINT: Control knob should be above decal on Post.
Place a Lock Washer on each of 4 Bolts FF and insert into
holes, then tighten.
Hardware Used:
6
Item 61436 Only: Assemble Reflector: Reflector Panels A come
packaged in 2 brown boxes with 2 panels in each box. Hardware
for assembly is already affixed to each panel. Place 2 panels side
by side. Remove the 2 cap nuts/washers that are affixed to one
panel. Insert the affixed bolts into the open holes on the adjacent
panel. Place the washer over the bolt and screw on cap nut. Repeat
these steps until all four panels are joined. Then locate the
Reflector Center Cap. Remove the cap nuts and washers located at
the top of each Reflector Panel to allow assembly of the Center
Cap to each panel. Align the holes in the Center Cap with the bolts
on each panel and affix washer and cap nut to complete assembly.
Contact us for assistance: (866) 985-7877 | www.wtliving.com
H : align the holes in the
6 x CC Bolt (M6x35)
12 x HH Washer (M6)
6 x DD Nut M6
over Post F and down over Post Supports H
B to Posts F :
4 x FF Bolt w/ Lock Washer
(M6x12/M6)
to the Base
I
7