Table of Contents
Advertisement
ASSEMBlY
PREPARATION
Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents
list and hardware contents as listed on previous pages of this manual. If any part is missing or damaged, do not attempt
to assemble this product. Contact Customer Service for replacement parts.
ESTIMATED ASSEMBlY TIME: 60 minutes
Tools Required for Assembly (NOT included):
NOTE: This heater has an Electronic Ingition and requires the installation of 1 AAA Battery. The battery should be installed
by unscrewing the RED IGNITER BUTTON.
1
Loosen and remove Bolt BB that comes pre-assembled to the
Base
. Then loosen and remove the hardware II and JJ that is
I
pre-assembled to the Wheel Brackets and Wheels. First, attach
the Wheel Brackets to the Base by aligning holes in Wheel
Bracket with corresponding holes in Base, and insert 3 Bolts BB
through holes and hand-tighten. Repeat with second Wheel
Bracket, then tighten with wrench.
Hardware Used:
2
Attach the Post Supports
bottom of each Post Support with the hole on the Base. Insert 1
Bolt AA through the hole in the support and into the Base, then
hand-tighten. Repeat with the other 2 Post Supports, but leave
hardware slightly loose until next step.
Hardware Used:
Contact us for assistance: (866) 985-7877 | www.wtliving.com
• Phillips screwdriver w/medium blade
• Leak test solution (see page 10 for info)
6 x BB Bolt (M6x16)
2 x II Bolt w/ Nut (M8)
2 x JJ Bolt w/ Lock Washer (M6x8/M6)
to the Base
. Align the holes in the
H
I
3 x AA Bolt (M8x16)
• Adjustable wrench (2)
6
Hide quick links:
Advertisement
Table of Contents
