Manual Mode; Manual Replacement Of Oil (Setting The Amount Of Oil To Be Replaced) - YAMADA AFC-9000S Operation Manual

When the machine is in Normal mode, the machine automatically skips to Step 10.
8 . The NEW FLUID lamp and the FINISH key flash. (These lamp and key flash only
when the machine is in Semi Auto mode.)
9. To finish replacing the oil, press the FINISH key.
To supply the car with new oil whose amount is the same as that of the removed oil, press the MANUAL MODE key,
then press the START key.
10. Supply the car with new oil whose amount is the same as that of the removed wasted oil.
11 . The signal light "blue" flashes when the remaining time becomes approximately 30 seconds.
12. Check the level gauge, and make fine adjustments if the replaced oil is too much or too little.

3-5-2 Manual mode

■ Manual replacement of oil (Setting the amount of oil to be replaced)

1. Connect the power cable to the AC outlet. (The buzzer sounds for one second.)
2. Press the POWER key.
3. Press the MANUAL MODE key once and select "ADD" or
press the MANUAL MODE key twice and select "REMOVE."
4. Set the amount of oil to be replaced with the ▲key and/or the▼ key, and press the SET key.
Perform this operation when "0.5" or more is displayed as the amount of oil.
5. Insert the flexible nozzle into the level gauge hole.
6. Press the START key.
7. New oil is supplied to the car (or the wasted oil is removed from the car).
8. The signal light "blue" flashes when the remaining time becomes approximately 30 seconds.
9. Oil replacement finishes when the amount of the supplied oil reaches the value you set.
(If the wasted oil is removed, the operation finishes when the set amount of wasted oil is removed or the all wasted oil
is removed from the oil pan.)
11