Cvt Mode - YAMADA AFC-9000S Operation Manual

12. The signal light "blue" flashes when the remaining time becomes approximately 30 seconds.
13. Oil replacement finishes when the amount of new oil and that of wasted oil reach the value you set.
Stop idling the engine.
14. Check the level gauge, and make fine adjustments if the replaced oil is too much or too little.
Number of alternate replacement operations and waiting time varying depending on the amount of oil to be replaced
you set
Amount of oil to be
Set value
replaced at a time
3 L 600 mL
4 L 800 mL
5 L or more 1000 mL
* You can change the waiting time. See "P04: waiting time for alternate oil replacement" of Section "Settings" on page
16.
** These values are applicable when the temperature of new ATF is 20°C. (Use these values as the guideline only
because the replacement time varies depending on the oil type and the temperature condition.)

■CVT mode

1. Connect the power cable to the AC outlet. (The buzzer sounds for one second.)
2. Press the POWER key.
3. Press the AUTO MODE key three times to select CVT mode.
4. Press the SET key.
Insert the nozzle into the level gauge hole securely.
When you hold down the SET key
(for approximately two seconds), the machine enters "Semi Auto mode."
5. Insert the flexible nozzle into the level gauge hole.
6. Press the START key.
7. Remove the wasted oil until the oil pan gets empty.
Number of
Waiting time*
replacements
5 times 10 seconds
5 times 10 seconds
5 times (When you
15 seconds
set "5 L")
10
Total replacement time**
Approximately 4 minutes
Approximately 5 minutes
Approximately 6 minutes and 30 seconds or more
When the machine is in Semi-Auto mode
Digital display: "セミオート"appears on
Insert the nozzle into the level gauge
hole securely.
the display.