Dahua IP Villa System Quick Start Manual page 16

Tap Cancel, you need to configure parameters for the indoor monitor (VTH) according
to your needs.
Select an uninitialized device.
The Device Init interface is displayed. See Figure 2-10.
Initialization of all intercoms must be done on the indoor monitor (VTH); otherwise

the quick configuration might fail.
If no device is uninitialized, tap Next to go to the configuration interface. See

Figure 2-11.
Enter password, confirm password, and email for the device you are to initialize.
Tap OK.
The intercom list interface is displayed again. See Figure 2-11.
All intercoms displayed
Device Init
Installation and Configuration
8