Prestart Inspection Checklist - Snorkel TM12 Series Operator's Manual

Prestart Inspection Checklist

Item
Operator's Manual
Electrical System
Battery fluid level
Battery terminals
Batter charger
Cables and wiring harness
Hydraulic System
Fluid level
Hoses, tubes, and fittings
Tires
Wheels
Parking Brakes
Lower Control Station
Operating controls
Emergency stop
Lowering alarm
Level Sensor
Emergency Lowering
Structures
Weldments – Chassis, mast, platform, etc.
Front and rear mast bearings
Fasteners
Upper Control Station
Guardrail system
Platform floor
Lanyard anchors
Entry chain
Brakes
Operating controls
Emergency stop
Lowering alarm
Drive motion alarm
Placards and Decals
TM12 – 8210027
Chapter 8 – Prestart Inspection
Inspect For
In place, all pages readable and intact
Proper level
Clean, connectors tight
Proper operation
No wear or physical damage
Between full and add marks with platform stowed
No leaks, all fittings tight
Good condition
All fasteners present with no signs of looseness
Proper operation
Proper operation
Shuts off lower controls
Sounds when platform lowers
Sounds tilt alarm
Proper operation
Welds intact, no damage or deformation
In place, no damage or deformation
In place and tight
Welds intact, no damage or deformation
All fasteners in place, no loose or missing parts
No damage or deformation
Clean to prevent slip and fall hazards
In place, no damage or deformation
In place, no damage or deformation, proper operation
Proper operation
Proper operation
Shuts off upper controls
Sounds when platform lowers
Sounds when aerial platform moves
In place and readable
Ok
27