Description Of The Controls - Hyundai VK 148 Instruction Manual

• There is a cut-off device that works if the kettle is overheated. It switches the kettle off
when there is no water inside or the water level is too low. Wait until the kettle cools down
completely to start boiling after the cut-off device was activated. The kettle will not turn on
while too hot. Before switching on the kettle always check that there is water inside the kettle
and the water level is not too low.
• Fill the kettle with cold water only.
• Switch the kettle off before removing it from the base.
• The kettle must be used only with the base provided.
• If the kettle is overfilled, boiling water may be ejected. Don´t overload above the MAX mark
on the kettle!

Description of the controls

P1. ON/Off switch
P2. ON/OFF indicator light
P3. Water level scale
P4. Lid
P5. Button for open hinged lid
P6. Multi-directional base
Instructions for Use
Before you start:
Before first time use, boil and empty water in the kettle several times.
Check bellow mentioned recommandations for Kettle use:
1) Unwind sufficient cord from the storage area to reach the power outlet.
Then place the power base on a dry, flat surface.
2) Open the lid and fill the kettle with cold water.
3) Make sure that the water level is between the minimum and maximum marks on the water
level scale. Do not switch on the kettle when empty.
4) Check and correct the filter's position before boiling the water.
The automatic shutt off switch may not work properly without the filter.
5) Close the lid and place the kettle back on the base.
6) Plug to AC outlet with the voltage corresponded to the information on the product label.
7) Switch the kettle on by the main switch. The indicator light will go on showing that the water
is being boiled.
ENG - 19
ENG