Invacare Soft Tilt User Manual page 8

Invacare® Soft Tilt
Place the main module
the symbol represented in the zoomed image P. Head facing
towards the head end of the bed and feet towards the foot end
of the bed.
3.
Fix the main module onto the crossbars of the mattress support
frame, by placing the carrige-bolt , trough the designated bracket
on the main module , washer and nut, from underneath on both
sides of the bed.
4.
Cut all the zip ties to release the wings, before you start the motors.
Make sure new zip ties are placed in the same location when the
main module is to be removed from the bed.
Wiring
The control box and hand control is to be hung at the footboard.
Connections at the control box
Q Power supply
R Hand control
S Right motor
T Left motor
8
 onto the crossbars O, following 1.
Run the motor cable underneath the bed frame toward the foot
end (indicated by the arrow in the image), on both sides of the bed
and fix each of the cables with zip ties onto the frame tube. Ensure
that both motor cables are tighten with zip ties (marked by the
circles in the picture), first zip tie near the motor and the last 3 on
the frame tube toward the foot end. Make sure the end of the zip
ties, are not facing outwards from the bed frame.
2.
Connect the hand control to cable R and connect the power cable
Q to the mains. The hand control cable is marked
clip corresponding to on the control box cable.
3
3.
Connect the cables of the right and left motor to the two extension
cables and from the control box. The right motor cable is
S T
marked on the cable clip corresponding to
1
the control box and the left motor cable is marked
clip corresponding to on the control box cable. Deactivate the
2
emergency stop, turn the system on, activate manual mode and use
the hand control to check that the left and right motor are correctly
connected to the control box (see chapter Usage for detailed
instructions).
Ensure that all cables run underneath the bed frame tubes and
move the bed all the way up and down to ensure no cables
are getting squeezed.
on the cable
3
on the cable from
1
on the cable
2
IVCNORBE221119