Download Print this page
SOMFY EOLIS Inteo Wind Control Installation And Operating Instructions

SOMFY EOLIS Inteo Wind Control Installation And Operating Instructions

Advertisement

Quick Links

DESCRIPTION
Catalog No: 6301021
INSTALLATION PROCEDURES
SOMFY SYSTEMS, INC.
47 Commerce Drive
Cranbury, NJ 08512
SOMFY SYSTEMS, INC. reserves the right to change,
update or improve this document without prior notice.
EOLIS
Inteo Wind Control
Installation and Operating Instructions
The new Somfy Eolis is a single motor control designed for residential
use. It includes a wind sensor and a low voltage switch. Wind speed is
continuously monitored, triggering the control to retract awnings or
lower shutters automatically as needed.
positions can be programmed.
weatherproof enclosure and includes watertight strain-relief fittings for
wires entering the box.
1.
2.
The wind sensor should be placed close to the awning or shading
3.
system to make sure the wind speed is measured at the product.
Guard against installing the wind sensor too close to an obstruction
such as a chimney, gutter or the window treatment itself, which could
block the wind and cause erroneous sensor readings. The sensor
should not be more than 100 feet from the control.
cover of the sensor and connect the two-wire cable (included) from the
terminals on the sensor to the terminals on the control. Refer to the
diagram on the next page.
4.
SOMFY CANADA
6315 Shawson Drive, Unit #1
Mississauga, Ontario L5T1J2
This new control is packaged in a
The Eolis should be mounted as close to the motor as possible. If
mounted outside, ensure that the connections are facing down to avoid
rain seepage. Avoid mounting the control against any metallic surface,
as this may affect the radio reception.
Connect high and low voltage wires according to the wiring diagram
on the next page.
It is recommended that the low voltage wiring is
done first, for easier access to the terminals.
watertight strain relief fittings to maintain the weatherproofing of the
enclosure.
The low voltage switch should be located no more than 100 feet from
the Eolis Control.
SOMFY MEXICO S.A. De C.V.
Calle 3 No.47, Loc.E-5
Fracc Ind. Alce Blanco
Nau.,Edo. de Mex C.P . 53370,Mex
CAT. NO: 2500021
Two user-defined intermediate
Make sure to use included
Remove the back
C
SOMFY SYSTEMS, INC.
1/01

Advertisement

loading

Summary of Contents for SOMFY EOLIS Inteo Wind Control

  • Page 1 Installation and Operating Instructions DESCRIPTION The new Somfy Eolis is a single motor control designed for residential use. It includes a wind sensor and a low voltage switch. Wind speed is continuously monitored, triggering the control to retract awnings or lower shutters automatically as needed.
  • Page 2 WIRING DIAGRAM Wind Adjustment Low Voltage Switch DOWN COLOR CODE MTRCOM NEUT BLACK WIND WIND DIR1 DIR2 GREEN MOTOR WHITE DOWN DOWN NOTE: Mount control with fittings facing downward! GROUND WIND NEUTRAL SENSOR OPERATING INSTRUCTIONS System Set Up Operating Procedures With power off, wire the control as indicated above.