Leuze electronic CU411-RS4 Manual page 8

Safety
This connection unit was developed, manufactured and tested in line with the appli-
cable safety standards. It corresponds to the state of the art.
Intended use
The CU411-RS4 connection unit makes it possible to exchange a safety sensor
from the RS4 series for a RSL 410 or RSL 420 safety sensor without changing the
wiring.
CAUTION
Observe intended use!
 Only operate the device in accordance with its intended use.
The protection of personnel and the device cannot be guaranteed if the device
is operated in a manner not complying with its intended use.
Leuze electronic GmbH + Co. KG is not liable for damages caused by improp-
er use.
 Download the
safety sensors at www.leuze.com
 Read this supplement and the
and RSL 420 safety sensors before commissioning the device. Knowledge of
these documents is required in order to use the equipment for its intended pur-
pose.
NOTICE
Comply with conditions and regulations!
 Observe the locally applicable legal regulations and the rules of the employer's
liability insurance association.
Original operating instructions
Original operating instructions
for the RSL 410 and RSL 420
for the RSL 410
EN
8