Advertisement
Using Your Spire Terminal
To turn the terminal on press the power button found on the left hand side of the terminal
until the screen lights up. The terminal will automatically scroll through several screens of
information until the Welcome screen is displayed.
To turn the terminal off press the power button for three seconds, ensure SHUTDOWN is
highlighted and press the green ENTER key.
PLEASE NOTE: Highlighting RE-START will re-start the payment application.
Changing and replacing the battery on SPw60 and SPw70 terminals
If you have a portable terminal it will use a removable, rechargeable lithium ion battery
module. The battery module will need to be charged when you receive a new terminal,
a replacement battery, and during day-to-day use.
Battery Module Installation and Replacement
1. Place the terminal face down on the counter and remove the battery cover by applying
pressure and sliding it backwards as shown below.
2.
If a battery module is already fitted, place your thumb nail into the recess at the base
and pull upwards. The battery module will lift out of the compartment. See section
'Safety Information and Battery Guarantee' in the introduction for battery module
disposal instructions.
3.
Remove the packaging from the new battery module and ensure the connections are
aligned with those in the battery compartment. The Spire Payments logo should be
facing upwards.
4.
With the contacts aligned, insert the module into the battery compartment by pushing
downwards.
5.
Slide the battery compartment cover back into position.
8 Using Your Spire Terminal
Advertisement
