Advertisement
PIN-Pad -
Spire SPp10
Quick Setup Guide
1.
Ensure the terminal is in its idle state
and unplugged from the electrical socket.
2.
Remove the cable tidy from the terminal.
3.
Remove the new SPp10 PIN-Pad from its packaging.
4.
Push the new SPp10 PIN-Pad's plug into the socket on the rear of the terminal
identified by a yellow PIN PAD label. Once it is correctly located you will hear a soft
click.
5.
Plug in the terminal into the power socket.
6.
Neatly route all the cables over the top of the terminal so they do not overlap one
another.
7.
Ensure the cable tidy is orientated with the notches on either side sliding in first to the
slots on the side of the terminal's feet and slide home until you hear a click. Ensure
both sides of the cable tidy are correctly located.
8.
Turn the terminal over and, if required, switch the electrical outlet on.
9.
Turn on the terminal by pressing on the power key on the left hand side.
10.
Please proceed to page 8 – Using your terminal.
PIN-Pad - SPp10 7
Advertisement
