Advertisement
WiFi Terminal -
What's in the box?
The SPw60 terminal
Battery
Paper Roll
The Power Supply Unit (PSU)
WiFi access point (Optional)
Network cable (if you have chosen a WiFi access point)
WiFi access point power supply
QUICK SETUP GUIDE
1.
Place the terminal face down, remove the battery cover, remove the packaging and
insert the battery and replace the cover.
2.
Install the paper roll by opening the printer door and removing any packaging from
the printer compartment. Fit the paper roll as shown below leaving 10cm of paper
protruding from the top of the terminal and close the printer door.
3.
If using a Spire WiFi Access point connect the network cable to the WAN port on the
supplied WiFi access point and to your Internet connection point.
4.
Insert the power supply plug directly into the rear of the terminal. Plug the power
supply into the electrical outlet. Charging of the battery will take between 2 and 4
hours. The battery condition is indicated in the top left hand corner of the display when
the terminal is switched on. When not in use keep connected to the power supply to
maintain charge.
5.
Turn on the terminal by pressing on the power key on the left hand side.
6.
Please proceed to page 8 – Using your terminal.
Spire SPw60
WiFi Terminal - SPw60 5
Advertisement
