Table of Contents
Advertisement
Installation Guide
3.1.2. On the right side of the screen select the desired user in the drop-down
menu. Click on the new layout tab, then select one of the predefined
layouts with the correct number of channels required for layout.
Avoid looking at the live screen at this point as the images will be
scaled incorrectly, this will be autocorrected in the next few steps
3.1.3. Click save at the top
3.1.3.1. Note: Failure to click save will result in lost work
3.1.4. Re-arrange the windows using the following steps.
3.1.4.1. Click save, click in the desired window A, B, C, or D
3.1.4.2. Click and hold any corner of the desired window to change
3.1.4.3. Click and hold in the center of a window to drag location around the screen. Note: dragging a
3.1.4.4. Sizing and moving can also be done via numerical
L280-0974 REV A
ilex
55
window size. Note: if the window size becomes larger than the screen it will revert to its
original size.
window past the edge of the screen is not allowed and will return to its original location. In
most cases, change the size of the window to be smaller prior to moving the window around
the screen, then enlarge if needed.
data at the bottom of the page. See Coordinate
information. X & Y are the coordinate points
relating to the overall location of window in the
monitor. W and H are the width and height of the
desired window. Enter the height and width of the
window first, then adjust location. Values that are
invalid will revert to original state. If there is not
data in a given row, that signifies that window is not
active in the given layout.
www.imagediagnostics.com
Page 8
Advertisement
Table of Contents
