Navigating Video Output Menus On Tablet - idi ilex 55 Operator's Manual

For units using msv2 video signal router

Hide thumbs Also See for ilex 55:

Installation manual (10 pages)

Installation manual (21 pages)

Table Of Contents

Table of Contents

Operator Manual

On/off Button, use the green toggle switch/thermal breaker to turn the system on

and off and to reset the breaker.

Maximum duty cycle of the actuator is 10% or 2 minutes of continuous

use followed by 18 min. not in use. Exceeding this limit could damage

the device and require replacement.

When the red emergency stop button is pushed in, elevation of the monitor is not

allowed. Always push the red emergency stop button when moving the ilex55

to reduce the risk of damage to the unit. Reset by rotating the button a quarter

turn.

To use the speakers with an external audio device with Bluetooth® capability,

perform the following steps:

1. Ensure that the green toggle power switch is on and lit up.

2. On the cart's audio control panel, ensure that the "INPUT SELECT" switch is set

to "BT."

3. Turn the power on to the Cart's audio system by turning the rotary Volume Control

knob clockwise so that the red PWR light lights up.

4. If the system doesn't automatically sync, press in the white Volume Control knob

button and hold it in for 3 seconds (or until the 'BT' Bluetooth® indicator light

begins to blink. (You may also hear the system prompt say 'Power ON').

5. Turn on a Smart Device and locate a list all available Bluetooth devices. The

Network Name will appear as 'BT-RY' on your Smart Device list. No password is

required to connect, but if you are prompted, enter '0000' (4 zeroes).

6. As the Smart Device and the cart are synchronizing, the LED indicator light on the

cart will blink progressively quicker and you will hear the system prompt 'Paring.'

7. When a successful connection is established, the LED indicator light on the cart will

stay lit without blinking and you will hear the system prompt, 'Your device is

connected', indicating that the unit is ready to transmit audio.

(Note: Audio Devices can also be connected to the Cart using cables that have a 3.5mm Aux

Jack or a ¼in. Microphone Jack. Move the "Input Select" switch to the corresponding format

and adjust the volume as desired.)