Gaskets; Accessories; Firescreen; Outside Air Kit - Jøtul F600 Firelight Installation And Operating Instructions Manual

139682-R04 F 600 9/19
4. Remove all remaining debris from the glass area using a wire
brush.
5. Apply a small bead of gasket/stove cement and the new
gasket. Do not overlap the ends of the gasket rope.
6. The F 600 utilizes glass that has an infrared coating on the
outer side. Orient the glass with the IR label facing out.
Center the panel over the gasket and reinstall the glass clips.
Important: Gradually tighten the glass clips in an alternating
pattern as you would tighten the lugs on an automobile
wheel. See figure 13.

6.7 Gaskets

Check door and glass panel gaskets for tightness. To check the
seal of the front door, close and latch the door on a dollar bill and
slowly try to pull the dollar bill free. If it can be easily removed,
the seal is too loose. Check several spots around the door, and
repeat the procedure on the ash pan door as well.
Gasket Replacement
1. Use pliers and a putty knife to remove the old gasket from
the door.
2. Thoroughly clean the channel with a wire brush.
3. Apply a small bead of cement to the channel.
4. Gently press the new gasket into the cement to seat it in the
channel. Close and latch the door and then reopen. Wipe any
excess cement squeezed out from around the gasket.
Gasket List for the Jøtul F 600
Description Size
Right door, ld375
Left door, ld375
Left door, middle ld250
Right glass, ld250
Left glass, ld250
Ash pan door, ld250
Right side load door, ld375

7.0 Accessories

Many accessories have been manufactured for use with the Jøtul
F 600. Only use accessories that are specifically designed for the
Jøtul F 600.

Firescreen

The Jøtul F 600 has been approved for use as an open fireplace,
with front doors open. This feature is especially nice when the
ambience of a fire is desired. Some care should be taken when
operating the stove as a fireplace.
• Always have the firescreen in place, attached to the stove
front.
• Never over load the stove: For the best appearance burn in
the traditional three log configuration.
• Reminder, when burning the stove with the screen in place,
you are sacrificing efficiency for aesthetics, and you will be
consuming wood at a much faster rate.
12
Length
ø9,5 mm (3/8") 900 mm (36")
ø9,5 mm (3/8") 900 mm (36")
ø6,4 mm (1/4") 410 mm (18")
ø6,4 mm (1/4") 1050 mm (42")
ø6,4 mm (1/4") 1050 mm (42")
ø6,4 mm (1/4") 1100 mm (45")
ø9,5 mm (3/8") 1400 mm (56")
Warning: Operate your Jøtul F 600 with the front doors fully
open and the firescreen in place or fully closed. Partially opened
doors may result in overfiring. Also, if doors are left partly open,
gas and flame may be drawn out of the stove opening, creating
risks from both fire and smoke.
Stove Gloves, pair
Heavy-duty, flame retardant material with full gauntlet.
Outside Air Adaptor 154333
In certain installations it may be necessary to provide outside
air to your Jøtul F 600 wood stove. Guidelines to determine the
need for additional combustion air may not be adequate for
every situation. If in doubt, it is advisable to provide additional air.
The outside air kit includes an adapter to mount onto the stove
that will accept the fresh air pipe. Installation will require some
additional materials:
A. The appropriate length of metallic pipe for a conduit of the
outside air (4" diameter).
B. A rain/weather resistant cap for the outside of the house.
C. A rodent screen - that is no larger than 1/4" mesh.

Floor Bracket Kit

Use of the floor bracket kit is required in all mobile home
installations to secure the stove to the floor. Complete installation
instructions and diagrams are supplied with each floor bracket kit.

Rear Heatshield

A stove rear heatshield has been specifically designed for the Jøtul
F 600 to reduce clearances off the rear of the stove to combustible
materials. Use of the heatshield does not affect the clearance off
the sides of the appliance.
See pages 16-17 for specific clearance requirements. Complete
installation instructions are supplied with the heatshield. No
other type of heatshield may be used on the rear of the Jøtul
F 600.

Bottom Heatshield

A bottom heatshield has been specifically designed for
the Jøtul F 600. It is required in all alcove installations.
Use of the bottom heatshield does not affect the floor
protection requirements discribed on page 6 of this manual.
No other type of heatshield may be used on the bottom of the
Jøtul F 600.

Stove-top Thermometer

Jøtul recommends the use of a magnetic stove-top thermometer