PB TEEN Hannah beauty station Assembly Manual

Hannah beauty station
Max. Load: 50lbs.

Parts Included:

A
Wall-mount Bracket
1PC

Tools required (not included):

This item is meant to be mounted to a wall using a French cleat mounting system which includes a wall-mounted
cleat and a product-mounted cleat. The wall-mounted cleat is mounted to the wall using the provided fasteners and
is thereafter used to engage with and support the product-mounted cleat to safely hold the item against the wall.
The wall-mounted cleat includes a sharp edge that must be facing up and away from the wall for this French cleat
mounting system to work properly. Also, the wall-mounted cleat includes an optional locking groove which is
designed to receive the head of a screw secured to
the product, as explained below:
A) With the help of one or two people, hold this
item against a wall at a desired location. Use
a level to make sure that the item is level and
then use a pencil to mark the wall along the
entire top edge. Carefully set the item aside.
B) On the backside of the item, position the wall-
mounted cleat so that it is engaged with the
product-mounted cleat located about three
inches down from the top of the item. Note, the
cleats may already be secured to each other.
Use a tape-measure to measure the distance
between the bottom of the wall-mounted cleat
cleat and the top of the item, as shown. This is
"Measurement (A)".
Note: This item is meant for drywall/wood stud
mounting only. If your walls are made from concrete,
brick or plaster, please consult your local hardware
store for assistance. For safety and ease of
mounting, installation is recommended using two
people.
B C
Anchors
2PCS
Screwdriver, Level, Tape measure, Pencil, Stud-Finder
Screws
2PCS