PB TEEN Half-Pipe Storage Quick Start Manual

Half-Pipe Storage
PRE-ASSEMBLY:
•
Please read all instructions before assembling.
•
Two-adult assembly is recommended.
•
Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or
hardware.
•
Do not use power drill as it may cause cracking
PARTS INCLUDED:
E – Side Panel – 2 pcs
H – Storage Base – 2 pcs
HARDWARE INCLUDED:
I – Hex Bolt – 12 pcs
(1/4"x25mm)
O – Allen Key – 1 pc
TOOLS REQUIRED (but not included):
Phillip Head Screwdriver
ASSEMBLY:
1. Aligning the pre-drilled holes on the Half Pipe Base (G) to the pre-drilled holes on the top of the
Storage Base (H). Insert 4 Hex Bolts (I) through the Storage Base (H) and into the Half Pipe Base (G)
as shown below. Tighten using the Allen Key (O) and repeat for the other side.
Figure 1
F – Half-Pipe Top – 2 pcs
J –Connecting Screw – 16 pcs
(5/32"x28mm)
P– Wooden Dowel – 4 pcs
(8x30mm)
1/12
www.pbteen.com
G – Half-Pipe Base – 2 pcs
K – Connecting Sleeve – 16 pcs
(5/32"x14mm)