Safety Considerations - Dustcontrol DC 11-Module User Instruction

Safety Considerations

Read all instructions before attempting to operate this
machine.
Th e equipment must be installed and maintained properly
by qualifi ed personnel who have study this instruction. Dust-
control does not take responsibility for defective installation
or maintenance.
Warning! When using electric machines, basic safety pre-
cautions should always be followed to reduce the risk of fi re,
electric shock and personal injury, including the following:
1. Work area environment
Keep the area around the central unit clean. Do not
store or work with fl ammable liquids or gases near the
machine.
2. Overload
If there is an alarm signal it should be carefully checked
out to see that the machine is un damaged. If there are
any damaged parts these should be repaired by a Dust-
control authorised service centre. Always follow the
regulations pertinent to the material you are working
with. Do not use the machine for purposes that it is not
intended for.
3. Bodily injuries
Warning - High negative pressure
Do not start the fan without having it connected to
the duct work. Never let the suction come in contact
with parts of the body, for example a hand. Th e pump
generates a high negative pressure, severe injury may
result.
Warning - Very hot exhaust air
Exhaust air can be very hot.
4. Clamp risk
When emptying the container you normally should
put a trolley or moveable load bearing item under
the container before the eccentric lock is released. Be
aware of the clamp risk - the container can be heavy.
Also, when transporting the whole machine, especially
when it is equipped with wheels, please be careful. Th e
unit is very heavy and there can be be risk of an accident,
especially on sloping surfaces.
5. Electricity
Do not repair the electric components yourself, get a
qualifi ed electrician. Faults may cause injury. Th e elec-
trical connections may only be performed by a certifi ed
electrician. See also under section 9, 'Warning'.
6. Important measure
Never work with the dust extractor without first
switching it off and locking the isolator.
7. Care
Always clean the fi lter before you unfasten the collected
material from the cyclone. When you handle the dust
valid regulations must be followed.
8. Checking for damage
Check the machine regularly for damage. If there are any
damaged parts these should be repaired by a Dustcontrol
authorised service centre.
9. Warning
Use only accessories and replaceable parts which are
available in the Dustcontrol catalogue. When using non-
genuine parts, especially fi lters and plastic sacks, dust
leaks could occur which may be hazardous to health.
DC 11-Module 7.5 kW - 19 Part No 94141