Notes On Firmware Update By Using Lp Maintenance Tool - Hitachi Compute Blade Series Update Manual

Notes on Firmware Update by Using LP Maintenance Tool

LPAR manager does not start when rebooting server blade
At the last step of firmware update by using LP Maintenance Tool, the server blade is
rebooted to start the LPAR manager in new firmware version and/or revision. However, in
the event that rebooting the server blade does not start LPAR manager, start a remote
console and check the status of the server blade.
Check if the remote console shows the following messages. When the following message
appears, take actions according to the "What to do".
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Static Version Upgrade/Revision Update by LP Maintenance Tool
Hitachi Compute Blade Logical partitioning manager Version Upgrade / Revision Update Guide
PMBR booter started.Ext INT 13h not available.Press key to reboot.
Booting LPAR manager failed.
Turn off power of the server blade once, and then turn on power of the server blade.
LP Loader detected enable H/W Memory Dump setting in this system. [INFO:XX]
Please set H/W Memory Dump setting to disable.
LPAR manager cannot boot due to the Enabled hardware memory dump setting.
Set Disabled in the [hardware memory dump] setting, and turn on power of the server blade
again.
4-9