Icon List - Hitachi Compute Blade Series Update Manual

LPAR manager does not start when rebooting server blade
At the last step of firmware update, the server blade is rebooted to start the LPAR manager in
new firmware version and/or revision. However, in the event that rebooting the server blade
does not start LPAR manager, start a remote console and check the status of the server blade.
Check if the remote console shows the following message. When the following message
appears, take actions according to the "What to do".
Message Content
Explanation
What to do

Icon List

This section describes the icons used in HVM Navigator.
No. Icon
1
2
3
Static Version Upgrade/Revision Update by LP Maintenance Tool
Hitachi Compute Blade Logical partitioning manager Version Upgrade / Revision Update Guide
LP Loader detected enable H/W Memory Dump setting in this system. [INFO:XX]
Please set H/W Memory Dump setting to disable.
LPAR manager cannot boot due to the Enabled hardware memory dump setting.
Set Disabled in the [hardware memory dump] setting, and turn on power of the
server blade again.
Icon Description
Shows that the successful completion of F / W
Update.
Shows that the successful completion of F / W
Update.
(At least one error during the execution shows that a
retry was performed.)
Shows that the failure F / W Update.
Window
Main Window
Main Window
Main Window
2-41