Omron CPM2C Operation Manual page 103

Panel Installation
4-3-2 Compatible Programming Consoles
CQM1-PRO01-E
The C200H-PRO27-E Programming Console can be installed in a control panel
as shown in the following diagram. (The C200H-ATT01 Mounting Bracket is sold
separately.)
Mounting Bracket
Panel thickness: 1.0 to 3.2 mm
Allow at least 80 mm for the cable connector above the Programming Console.
37
There are two Programming Consoles that can be used with the CPM2C: The
CQM1-PRO01-E and the C200H-PRO27-E. The key functions for these Pro-
gramming Consoles are identical.
Press and hold the Shift Key to input a letter shown in the upper-left corner of the
key or the upper function of a key that has two functions. For example, the
CQM1-PRO01-E's AR/HR Key can specify either the AR or HR Area; press and
release the Shift Key and then press the AR/HR Key to specify the AR Area.
Attached Connecting
Cable (2 m)
Mounting hole dimensions
(DIN43700 standards)
Two screws
15
At least 80 mm is required.
Either connector may
be used.
About 70 mm is required.
Section 4-3
+1.1
186
- -0
+0.8
92
- -0
LCD display
Mode switch
Operation keys