Philco P-100 Instruction Manual page 20

3、Assembly Step
Figure 1
Figure 2
Figure 4
Figure 5
Figure 6
Figure 3
Figure 7
Step 1:Use a screwdriver to remove the fixing
screws on the door (Figure 1), pay attention to
put the screws in eye-catching position, will
be used later.
Step 2:Pls let the main control terminal cross
through the handle base (Figure 2), and then
the handle base hole alignment placed on the
door as shown in Figure (Figure 3).
Step 3:Use a screwdriver to tighten the screws
(4) in turn (Figure 4), you can adjust the upper
and lower positions, reducing the gap of
plastic parts and the door。
Step 4:Insert the main control terminal into
the corresponding terminal of handle cover
assembly (Figure 5), pay attention to the
direction of the terminal, the direction can not
be inserted.
Step 5:Insert the handle cover inserted into
corresponding position of the handle base (see
Figure. 6) to check whether it's suitable or not.
Press other three sides of handle cover.
(Figure 7).
19