Integrated faucet with optional above-deck mixing & smartherm temperature limiter (9 pages)
Summary of Contents for American Standard DXV Rem D35100800
Page 1
INSTALLATION INSTRUCTIONS ™ Widespread Lavatory Faucets Model D35100800 Thank you for selecting DXV by American Standard. To ensure that your installation proceeds smoothly, please read these instructions carefully before you begin. RECOMMENDED TOOLS AND MATERIALS ROUGHING-IN DIMENSIONS: In the United States:...
Page 2
SPOUT ASSEMBLY TEE ASSEMBLY Turn off hot and cold water CAUTION supplies before beginning. slot SLOT INSTALL VALVE BODIES (10) (12) Note: VALVE BODY marked Hot is installed in the left Mtg. hole, VALVE BODY marked Cold in the right when facing front of fitting.
Page 3
INSTALL POP-UP DRAIN Fig. A. Fig. B. DRAIN BODY Fig. B. REMOVE FLANGE Fig. A. Fig. B. Fig. A. (3). Fig. B. TIGHTEN LOCKNUT INSTALL DRAIN FROM REAR OF SINK BELOW FIXTURE DRAIN OUTLET Note: FLANGE GASKET AND POP-UP KNOB Fig.
Page 4
ATTACH CABLE CONNECTOR Fig. A. Fig. B. Fig. A. Fig. B. Note: Fig. B. 1-1/4” O.D. CHECK OPERATION OF POP-UP Note: MAKE WATER SUPPLY AND WASTE CONNECTIONS NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS NOT INCLUDED AND MUST BE PURCHASED SEPARATELY. (1,1A) COUPLING 1/2"...
® Speed Connect Drain Troubleshooting Guide If sink does not hold water even though Stopper is in the “down” position: If Stopper does not raise up fully or sink drains too slowly: If you need to remove the Stopper: If you would like the ability to remove your Stopper simply by lifting it out of the drain: “Unlocked”...
STOPPER INSTALLATION PROCEDURE The Stopper can be installed two ways, “Locked” Mode (Stopper cannot be removed) or “Unlock” Mode (Stopper is removable). Locked Mode: Fig. G. Fig. G. “Locked” rear Fig. G. Fig. J. LOOP TOWARD REAR OF BIDET DRAIN Fig.