R&S SMB100B Getting Started page 44

®
R&S SMB100B
2. Press the [Setup] key on the front panel.
3. In the "Setup" menu, select "Settings > Save/Recall".
4. In the "Save/Recall" dialog, select "Operation Mode > Recall".
Navigate to the directory the file is saved in and select the MyTestSignal
file.
5. Tap the "Recall" button.
All instrument settings are restored and the display resembles
"Generating an RF Frequency Sweep
instrument display right before the settings were saved.
How to display all parameters with values different to their preset val-
ues
When you load a file to your instrument, you do not have enough informa-
tion on the changed settings. In such case, it is useful to visualize all
parameters that have been changed from their default state.
Getting Started 1422.1045.02 ─ 03
Trying Out the Instrument
Saving and Recalling Settings
Signal", on page 40, which shows the
Chapter 6.2,
44