R&S SMB100B Getting Started page 39

®
R&S SMB100B
Figure 6-1: Generating an unmodulated signal
Alternative ways to access the instrument functions
To fulfill the same task, you can also use the front panel keys or the setting
parameters provided in the frequency and level dialogs.
Try out the settings dialogs
1. In the "Frequency" tile, select "Frequency...".
a) In the "RF Frequency" tab, tap the "Frequency" field.
b) Set the frequency via the on-screen keypad.
2. Access the "RF Level" dialog via the "Level" tile.
a) In the "RF Level" tab, select "Amplitude".
b) Set the amplitude (level) via the on-screen keypad.
3. Select "RF State > On" to activate the RF signal generation.
Try out the front panel keys
► Use the [Freq], [Level], and [RF on/off] key on the front panel.
Getting Started 1422.1045.02 ─ 03
Trying Out the Instrument
Generating an Unmodulated Carrier
39