Setting Up The R&S Smb100B; Placing The R&S Smb100B On A Bench Top - R&S SMB100B Getting Started

®
R&S SMB100B
See also "Choosing the operating site"
Electromagnetic compatibility classes
The electromagnetic compatibility (EMC) class indicates where you can operate
the R&S SMB100B. The EMC class of the R&S SMB100B is given in the data
sheet under "General data".
● Class B equipment is suitable for use in:
– Residential environments
– Environments that are directly connected to a low-voltage supply network
that supplies residential buildings
● Class A equipment is intended for use in industrial environments. It can cause
radio disturbances in residential environments due to possible conducted and
radiated disturbances. It is therefore not suitable for class B environments.
If class A equipment causes radio disturbances, take appropriate measures to
eliminate them.
4.4 Setting Up the R&S SMB100B
See also:
●
"Setting up the instrument"
●
"Intended use"
4.4.1 Placing the R&S SMB100B on a Bench Top
To place the R&S SMB100B on a bench top
1. Place the R&S SMB100B on a stable, flat and level surface. Ensure that the
surface can support the weight of the R&S SMB100B. For information on the
weight, see the data sheet.
2. CAUTION! Foldable feet can collapse. See
on page 9.
Always fold the feet completely in or out. With folded-out feet, do not place
anything on top or underneath the instrument.
Getting Started 1422.1045.02 ─ 03
on page 9.
on page 8.
Setting Up the R&S SMB100B
on page 9.
"Setting up the instrument"
Preparing for Use
16