R&S SMB100B Getting Started page 43

®
R&S SMB100B
To save the instrument settings in a file
We assume, a test configuration as described in
Frequency Sweep
1. Press the [Setup] key on the front panel.
2. In the "Setup" menu, select "Settings > Save/Recall".
3. In the "Save/Recall" dialog, select "Operation Mode > Save".
4. Tap the "Filename", use the on-screen keyboard, and enter MyTestSignal.
5. Tap the "Save" button.
The file MyTestSignal.savrcltxt is stored in the default direc-
tory /var/user/.
To load saved instrument settings
You can restore the settings to the instrument at any time using the settings file.
1. Press the [Preset] button to restore the default instrument settings so you can
check that the stored user settings are restored afterwards.
Getting Started 1422.1045.02 ─ 03
Signal", on page 40.
Trying Out the Instrument
Saving and Recalling Settings
Chapter 6.2, "Generating an RF
43