Panasonic HL-C2 Series User Manual page 79

of "judgment output" (HI, LO, HI or LO, HI to GO, LO to GO, HI or LO to
GO), "At an alarm occurred", and "At an alarm released".
The initial value is set to "At timing input ON".
· Note that the settings of "Upper Limit/Lower Limit Value of Judgment Output"
and "Upper Limit/Lower Limit Hysteresis of Judgment Output" become effective
when the result of judgment output is set as a trigger condition.
· Note that the setting of "Number of Alarm Delay Times" becomes effective
when "At an alarm occurred" is set as a trigger condition.
Ex ） When the "Buffering Mode" is set to trigger mode, the operations of each
trigger condition are shown as follows:
Buffering start
Stand-by
At timing input
ON
At HI
At LO
At HIorLO
When HI turns to GO
When LO turns to GO
When HIorLO turns to GO
At an alarm occurred
Meas. status
At an alarm released
Meas. status
Normally, the measurement value is on hold at timing input ON status;
however, only in the case that the buffering mode is set to trigger mode or
sample trigger mode, and this function is set to "At timing input ON", the
measurement value is not on hold at timing input ON status during buffering
operation.
7
Specify the trigger delay.
This function is used for delaying the timing of trigger detection when the
buffering mode is set to trigger mode or sample trigger mode.
(Command description
Sets number of sampling times as the trigger delay value. Setting range is 0 to
100000000.
The status during the trigger delay is indicated as "Accumulating". The initial
value is set to "0".
Trigger generate
(Trigger point)
Accumulation of data
ON
Timing output
OFF
ON
HIorLO output
OFF
ON
GO output
OFF
ON
HIorLO output
OFF
Alarm
Normal
Alarm
Normal
"5-2-7 Trigger Delay: RTL/WTL")
5-7
Chapter 5 Buffering Command
Buffering stop or
Accu. amount reached
Meas ope
5