Panasonic HL-C2 Series User Manual page 77

・ Timing input stops when the accumulation amount has reached the setting value
or when buffering operation stops.
Buffering start
Stand-by
ON
Timing input
OFF
Changing the timing input from "ON" to "OFF" again deletes the previous data
and starts new data accumulation. Make sure to stop the buffering operation once
and load/save the accumulated measurement data before performing the next
accumulation.
Sample Trigger Mode
· When buffering operation starts, the trigger generation is turned to stand-by status.
· Accumulation of the measurement data for the setting sample trigger accumulation
amount starts after the setting trigger condition is generated.
· After completion of sample trigger accumulation, the trigger generation is turned
to stand-by status again.
(In this case, the status is indicated as "Accumulating".)
· When the setting trigger condition is generated again, accumulation of the setting
sample trigger amount starts.
· Accumulation operation stops when the accumulation amount has reached the
setting value or when buffering operation stops.
Trigger
Buffering start
generate
Stand-by
Be sure to set the sample trigger accumulation amount so that (accumulation
amount) ÷ (sample trigger accumulation amount) is an integer value.
3
Select the buffering type.
This function selects individual data accumulation or simultaneous data
accumulation on OUT1 and OUT2.
(Command description
OUT1 is set as a default.
The maximum accumulation data amount differs depending on buffering type.
Timing input Timing input ON accumulation
OFF amount reached
Accumulation of data
Sample trig. accu.
amount reached
Accumulation of data Stand-by
"5-2-3 Buffering Type: RTT/WTT")
5-5
Chapter 5 Buffering Command
Buffering stop
Stand-by Meas ope
Trigger
Buffering stop or
generate
Accu. amount reached
Accumulation of data
5
Meas ope