Advertisement
Quick Links
Advertisement
Related Manuals for hadewe g-file
Summary of Contents for hadewe g-file
- Page 1 Manual g - file art. 6231, 6232, 6233, 6234 FB 04-279 Rev. 0 Date: 11.02.2019...
-
Page 2: Table Of Contents
Index of Contents Safety Instructions Application Handling Instructions Troubleshooting Exploded Drawing Technical Data... -
Page 3: Safety Instructions
Safety Instructions Read this instruction manual in its entirety before you start operating the unit. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory mental capabilities lack experience knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. - Page 4 Safety Instructions For safety reasons wear goggles during the treatment. When working with materials, which might create dust or moisture, use a drilling unit with suction or spray technique. Wear a nose and mouth protection. Always follow the safety instructions, provided by the manufacturer of the materials being formed and used.
- Page 5 Safety Instructions Turn off the unit after work. Never clean the handpiece while motor is running. Before using the equipment, make sure that • the tool can be pushed far enough into the chuck (test this with a dipstick and clean the handpiece, if necessary), •...
- Page 6 Safety Instructions manufacturer, or an authorized specialist. Never remove the housing, especially not while the equipment is plugged into the socket, since some components are under electric voltage. unauthorized improper handling (e.g. trying to repair the unit) of the equipment will immediately nullify...
-
Page 7: Application
Application Please read through the instructions cause damages at the motor and carefully before using the unit and the electronic. carefully note the safety advice. For security reasons, only Always keep this manual accessible change the tool if the to any users of the drill. handpiece is turned off. -
Page 8: Handling Instructions
Working with faulty tools will cause a stronger vibration of materials used the handpiece. A damage or hadewe prevent a formation even devastation ball of rust. In cases in which a bearings, clamping technique or rust infestation was found within the motor could be the consequence. -
Page 9: Troubleshooting
Troubleshooting When the motor does not rotate When the handpiece becomes or stutters… warm… Possible reason: worn carbon Should handpiece become brushes warm or make loud running noises, probably the ball bearings in the The operations described below handpiece front part are worn. In should only be performed by skilled this case we recommend to send us persons. -
Page 10: Exploded Drawing
Exploded Drawing Explosive Drawing for Service/Repair Shops... -
Page 11: Technical Data
2014/30/EU directive EMC 2014/35/EU low voltage directive Safety Check A safety check must be done in hadewe GmbH – Grambartstraße 10 compliance with the regulations of 30165 Hannover – Germany the country where the device is used. The inspection interval is... - Page 12 GmbH Grambartstraße 10 30165 Hannover Germany info@hadewe.de www.hadewe.de...