Advertisement
Handling Instructions
Never put the handpiece into
any kind of liquid, and never
oil or grease the handpiece.
Clean its surface with a damped
cloth.
Pay
attention,
moisture
or
liquid
handpiece.
Never put any wet burs or
instruments
handpiece.
could damage the interior parts of
the handpiece.
Any
materials
hadewe prevent a formation
of rust. In cases in which a
rust infestation was found within the
handpiece,
thorough
and
examinations
proved, that the rust had a foreign
origin (which was usually caused by
the
tools
used
circumstances). Even in high-grade
steel instruments of well-known
manufacturers, formation of rust
can appear, e.g., through wrong
treatment with chemical cleaning
and
disinfection
extraneous
rust
parts of the handpiece in form of
rust bloom and causes pitting.
Therefore, when you not working
with the handpiece, always remove
the bur/tool from it.
that
no
enters
the
into
the
Its
moisture
used
by
inspections
always
have
in
these
liquids.
This
affects
internal
Always make sure that you
do not let the handpiece fall
down or exposes it to any
shocks. The ball bearings and the
motor could be damaged by this.
Only work with tools, which are
flawless. Do not work with tools
which
•
are bent or out of balance,
•
whose shaft is worn out or
•
are rusty.
Working with faulty tools will
cause a stronger vibration of
the handpiece. A damage or
even
devastation
bearings, clamping technique or
motor could be the consequence.
Working with high pressure
will not improve the outcome
of your work, since the
motor will even be slowed down. A
second
disadvantage
stronger impact on the ball bearings
and the motor, which will shorten
their life span in the long run.
8
of
the
ball
is
the
Advertisement
