Install The Hardware; Mounting Bracket - Axis Q3517-SLVE Installation Manual

AXIS Q3517-SLVE Network Camera
How to install the product

Install the hardware

Mounting bracket

CAUTION
Be careful of sharp metal edges. Use cut-resistant gloves during installation.
The mounting bracket has eight holes along the edge that should be used for fastening the bracket
to a wall.
To mount the bracket on a junction box, there are also holes for these mounting options:
• Standard-sized US double gang junction box
• Standard-sized US single gang junction box
• 4" square box
• 4" octagon box
Depending on whether you want to use a junction box, or route the cables through or along the
wall, follow the relevant instructions below.
To mount the camera on a junction box:
1. Attach the adhesive gasket to the back of the mounting bracket.
2. Route the network cable (and the multicable if required) through the junction box and
through the hole in the mounting bracket.
3. Attach the mounting bracket to the junction box with appropriate stainless screws.
To route cables through the wall:
1. Using the drill template drill 4 holes for mounting the bracket, and a hole for routing the
cables through the wall.
2. Attach the adhesive gasket to the back of the mounting bracket.
3. Route the network cable (and the multicable if required) through the wall and through
the hole in the mounting bracket.
4. Attach the mounting bracket to the wall with appropriate stainless screws.
10