Quick Start - US Steam SeaHawk User Manual

1) REMOVE TANK LID
Ø Lift both silver handles to remove.
2) ADD WATER
①Extraction Bottle
Ø Fill bottle completely and attached to the SeaHawk.
②Steam Reservoir Tank
ØRemove the cap on the steam reservoir and pour .8 Liters of tap
water and replace cap.
③Vacuum Collection Tank:
ØAdd .7 liters of water.
ØFill only to mark on the tank separators.
⑤Reassemble Tank Lid
Add essential oils to the water ONLY in the vacuum collection tank.
3) ATTACH HOSE
Ø Insert the vacuum hose with the release button on the
left side and the power command plug on top.
Ø Lift the silver hinge cover on the front of the SeaHawk
and insert the power command connector.
Ø Go to the Tool Application guide and select cleaning
attachment.
4) PLUG INTO ELECTRICAL OUTLET
Plug in the power cord and you will hear a beep and the green light will start
blinking.
Ø The SeaHawk should be the only appliance plugged into the power outlet.
Ø Use only a 12 gauge / 15AMP rated or higher extension cord.
Ø It will take 5 minutes for the SeaHawk to heat and be ready for use.
5) ON/OFF
Push down on the power button and the
start flashing, signaling the boiler is heating.
Ø Once the boiler reaches working pressure, the
light will go solid and the SeaHawk is ready to use.
If the Red "Low Water" light comes on and steamer starts
beeping:
Ø Turn off your SeaHawk and refill the reservoir tank.
Ø Push power button to restart and resume heating.
Ø The Orange
the boiler is heating.

Quick Start

light may blink during operation indicating
Orange light will
Orange
ON/OFF
6