Advertisement
1)
ADD WATER
① Extraction Bottle
ØFill bottle completely and attached to the Sea Hawk.
② Steam Reservior Tank
ØRemove the cap on the steam reservoir and pour .8 Liters of
tap water and replace cap.
③ Vacuum Collection Tank:
ØAdd .7 liters of water.
ØFill only to mark on the tank separators.
⑤ Reassemble Tank Lid and Tighten
Add essential or balsamic oils to the water ONLY in
the vacuum collection tank.
2)
ATTACH HOSE & ATTACHMENT
Ø Insert the vacuum hose with the release button on the
left side and the power command plug on top.
Ø Lift the silver hinge cover on the front of the Sea
Hawk and insert the power command connector.
Ø Go to the Tool Application guide and select cleaning
attachment.
3) PLUG INTO ELECTRICAL OUTLET
Ø Plug the power cord and you will hear a beep and the green light will start
blinking.
Ø The Sea Hawk should be the only appliance plugged into the power outlet.
Ø Use only a 12 gauge / 15AMP rated or higher extension cord.
Ø It will take 10 minutes for the Sea Hawk to heat and be ready for use.
4)
ON/OFF
Ø Push down on the power button and the
start flashing signaling the boiler is heating.
Ø Once the boiler reaches pressure, the
and the Sea Hawk is ready.
Ø If the
Red
"Low Water" light comes on and steamer starts
beeping, turn off your Sea Hawk and refill the steam fill
tank. Push power button to restart your Sea Hawk and
resume heating.
Ø The
Orange
boiler is heating.
Quick Start
light may blink during operation indicating the
Orange
light will
Orange
will go solid
ON/OFF
5
Advertisement
