Components Vacuum Button Steam Button Ø Push to Turn ON Ø Push to start making steam ON / OFF Steam Pressure Control Water Fill Tank Lid Clamps Removable Lid Vacuum Collection Tank...
Vacuum & Steam Control Vacuum ON/OFF Steam Button Ø Push button to turn ON vacuum Ø Push button to start building Ø Light must be solid before steam pressure. starting (no blinking light) Ø Blinking light = boiler is Ø Vacuum pressure can be adjusted heating and building pressure.
Ø Use only a 12 gauge / 15AMP rated or higher extension cord Ø It will take 5 minutes for the SeaHawk to heat and be ready to use ON/OFF 5) ON/OFF – Push BOTH the Steam & Vacuum Button Ø...
Page 6
Pull the trigger on the hose handle for 10 seconds to BLEED excess water from the hose. Hold over sink to catch excess water. Ø When only steam is released from the hose, your SeaHawk is ready to use STEAM CONTROL DIAL controls the amount of steam released.
1) Set steam control to low or medium steam pressure for most cleaning applications. High steam pressure is best utilized for only extreme stains or dirty areas. 2) Use tap water for quicker heating. You may use distilled water, but the SeaHawk will take longer to heat.
Extraction Your steam vacuum uses a separate reservoir tank to inject water into the steam as it’s released from the extraction nozzle. Use the extraction function in combination with the vacuum for deeper cleaning of soft and hard surfaces. Ø Use the extraction nozzle for cleaning furniture, curtains, mattress, windows, walls, and floors.
SOLUTION 1) The steam tank or the extraction bottle is out of water. Refill Beeping both tanks and restart the SeaHawk using the ON/OFF Button. 2) The vacuum collection tank is full. Empty and refill with clean water. Orange light is flashing This is OK, it means the boiler is working and heating.
1) Use hot, soapy water to clean brushes and nozzles. 2) Clean vacuum hose by activating the vacuum mode and suck water through the hose. 3) Clean the exterior of the SeaHawk with wet cloth. Ø Do not use solvents or detergents that could damage the plastic surface 4) Clean Vacuum Collection Tank: Ø...
7) Fill boiler with tap water to rinse. 8) If the rinse water is clear of mineral deposits, then the SeaHawk is ready for use. Ø You may need to re-rinse the boiler if the water is not clear...
Notices Read all instructions before using this steam cleaner. WARNING: STEAM GENERATED BY THE STEAM CLEANER IS EXTREMELY HOT AND WILL CAUSE INJURY IF IT COMES IN CONTACT WITH THE SKIN OR EYES. USE AS DIRECTED BY THE MANUAL AND ONLY AIM THE STEAM HANDLE AT THE CLEANING AREA. Ø...
5. DO NOT SEND IN A REPAIR WITHOUT AN RMA. WARRANTY Your steamer comes with a warranty which becomes effective on the date of purchase from US STEAM and is granted to the initial customer and is nontransferable. Any claims under this warranty must be made before the end of the applicable warranty period.
Page 15
Seats & Floors Automotive Combine steam and extraction into one system for more efficient detailing. A Better Way to Clean US STEAM® 2440 Chamber Street, Ste A Venus, TX 76083 www.ussteam.net (817) 297-7745...
Need help?
Do you have a question about the SeaHawk and is the answer not in the manual?
Questions and answers