Components Steam Button Vacuum Button Steam Pressure Control Knob Water Fill Tank External Reservoir Tank Extraction / Detergent Lid Clamps Vacuum Collection Tank ON / OFF...
3) PLUG INTO ELECTRICAL OUTLET Ø The SeaHawk should be the only appliance plugged into the power outlet Ø It will take 5 minutes for the SeaHawk to heat and be ready to use USE only a Heavy- Duty extension cord Master Power Ø10 or 12 Gauge...
Quick Start 4) HOSE CONNECTION Ø Lift silver lid and insert hose Ø Listen for a “click” when attaching 5) ON/OFF – Push BOTH the STEAM & VACUUM Buttons Vacuum Steam Vacuum ON/OFF Steam Button Ø Push button to turn ON the vacuum Ø...
Quick Start – Adjusting Steam Pressure 6) STEAM PRESSURE ADJUSTMENT Increase Decrease Turning the dial all the way to (-) is the lowest possible setting and NO steam will be released from the hose...
Page 7
Pull the trigger on the hose handle for 10 seconds to BLEED excess water from the hose. Hold over sink to catch excess water. Ø When only steam is released from the hose, your SeaHawk is ready to use 8) EXTRACTION When activated, the extraction feature sprays hot water along with steam for deep cleaning.
Ø Remove and replace extraction bottle Ø Push down on the bottle to set it in place 1) Check master power switch on back of SeaHawk. 2) The SeaHawk should be the ONLY appliance plugged into the electrical outlet: No power Ø...
Page 9
1) Set steam control to low or medium steam pressure for most cleaning applications. High steam pressure is best utilized for only extreme stains or dirty areas. 2) Use tap water for quicker heating. You may use distilled water, but the SeaHawk will take longer to heat.
HOW TO USE THE EXTRACTION The SeaHawk uses a separate reservoir tank to inject water or detergent into the steam. Combine Activate by pushing the extraction function with the vacuum for deeper and holding the cleaning on any surfaces. button on the hose ØUse the extraction nozzle for cleaning furniture,...
Checking the O-rings 2) Clean vacuum hose by activating the vacuum mode and suck water through the hose. 3) Clean the exterior of the SeaHawk with wet cloth. To avoid damage to the appliance or accessories, the O-rings on the safe pipes must be checked regularly for damage.
7) Fill boiler with tap water to rinse. 8) If the rinse water is clear of mineral deposits, then the SeaHawk is ready for use. Ø You may need to re-rinse the boiler if the water is not clear...
Notices Read all instructions before using this steam cleaner. WARNING: STEAM GENERATED BY THE STEAM CLEANER IS EXTREMELY HOT AND WILL CAUSE INJURY IF IT COMES IN CONTACT WITH THE SKIN OR EYES. USE AS DIRECTED BY THE MANUAL AND ONLY AIM THE STEAM HANDLE AT THE CLEANING AREA. Ø...
5. DO NOT SEND IN A REPAIR WITHOUT AN RMA. WARRANTY Your steamer comes with a warranty which becomes effective on the date of purchase from US STEAM and is granted to the initial customer and is nontransferable. Any claims under this warranty must be made before the end of the applicable warranty period.
Page 16
Seats & Floors Automotive Combine steam and extraction into one system for more efficient detailing. A Better Way to Clean US STEAM® 2440 Chamber Street, Ste A Venus, TX 76083 www.ussteam.net (817) 297-7745...
Need help?
Do you have a question about the SeaHawk and is the answer not in the manual?
Questions and answers