Driving The Machine; Shutting Off The Engine; Grinding A Stump - Toro STX-26 Operator's Manual

Driving the Machine

Use the traction controls to move the machine. The
farther you move the traction controls in any direction,
the faster the machine moves in that direction.
Release the traction controls to stop the machine.
CAUTION
When reversing, you may back into stationary
objects or over bystanders and cause serious
personal injury or death.
Look behind you for obstructions or
bystanders and keep your hands on the
reference bar.
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place the
throttle lever in the F
AST
You can, however, use the throttle position to operate
at slower speeds.

Shutting off the Engine

1. Park the machine on a level surface, engage
the parking brake (if applicable), and lower the
hydraulic lift.
2. Move the throttle lever to the S
(Figure 16).
3. If the engine has been working hard or is hot, let
it idle for a minute before turning the key switch
to the O position.
FF
Note:
This helps to cool the engine before you
shut it off. In an emergency, you can shut off
the engine immediately.
4. Turn the key switch to the O
remove the key.
CAUTION
A child or untrained bystander could
attempt to operate the machine and be
injured.
Remove the key from the switch when
leaving the machine, even if just for a few
seconds.
position for best performance.
position
LOW
position and
FF

Grinding a Stump

DANGER
This machine is capable of amputating hands
and feet.
• Always wear substantial, slip-resistant
footwear.
• Stay in the operating position while the
machine is running, and keep away from
moving parts.
• Keep all bystanders a safe distance away
from the machine.
• Stop the machine immediately if any
people or animals enter the work area.
WARNING
Grinding a stump throws wood chips, soil,
and other debris into the air, which could
injure you or bystanders.
• Always wear eye protection and long pants
when using the grinder.
• Keep all bystanders a safe distance away
from the grinder.
WARNING
The grinder is very loud when cutting a stump
and can damage your ears.
Always wear hearing protection when using
the grinder.
1. Start the engine, raise the grinder, set the
throttle lever to the F
machine to the stump to be ground.
2. Use the grinder control lever and the traction
control to position the grinder to the side of the
front of the stump, about 2 cm (1 inch) below
the surface (Figure
3. Start the grinder and wait for it to get up to full
speed.
4. Use the grinder control lever to swing the grinder
slowly across the face of the stump, cutting
away a swath of chips
Important:
The grinder automatically slows
down the speed at which it swings into the
stump to maintain the optimum flywheel
speed and not bog down in the wood.
17
position, and move the
AST
17).
(Figure 17).