Starting The Engine; Driving The Machine; Shutting Off The Engine - Toro STX-38 EFI Operator's Manual

a safe distance between the machine and any
hazard.
•
If the machine starts to tip, let go of the controls
and step away from the machine.
•
Do not park the machine on a hillside or slope.

Starting the Engine

1. Move the throttle lever midway between the
S and F positions
LOW AST
Figure 18
1. Key
2. Turn the key to the O
When the engine starts, release the key.
Important:
Do not engage the starter for
more than 10 seconds at a time. If the engine
fails to start, allow a 30-second cooldown
period between attempts. Failure to follow
these instructions can burn out the starter
motor.
3. Move the throttle lever to the desired setting
(Figure 18).
Important:
If the engine is run at high
speeds when the hydraulic system is cold
(i.e., when the ambient air temperature is
near freezing or lower), hydraulic system
damage could occur. When starting the
engine in cold conditions, allow the engine
to run in the middle throttle position for
2 to 5 minutes before moving the throttle
to fast (rabbit). At normal to high ambient
temperatures, run the machine at full throttle
for the best performance and cooling.
Note:
If the outdoor temperature is below
freezing, store the machine in a garage to keep
it warmer and aid in starting.
(Figure 18).
g024908
2. Throttle lever
position (Figure 18).
N

Driving the Machine

Use the traction controls to move the machine. The
farther you move the traction controls in any direction,
the faster the machine moves in that direction.
Release the traction controls to stop the machine.
CAUTION
When reversing, you may back into stationary
objects or over bystanders and cause serious
personal injury or death.
Look behind you for obstructions or
bystanders and keep your hands on the
reference bar.
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place the
throttle lever in the F
You can, however, use the throttle position to operate
at slower speeds.

Shutting off the Engine

1. Park the machine on a level surface, engage
the parking brake (if applicable), and lower the
grinder.
2. Move the throttle lever to the S
3. If the engine has been working hard or is hot, let
it idle for a minute before turning the key switch
to the O position.
FF
Note:
This helps to cool the engine before you
shut it off. In an emergency, you can shut off
the engine immediately.
4. Turn the key switch to the O
remove the key.
CAUTION
A child or untrained bystander could
attempt to operate the machine and be
injured.
Remove the key from the switch when
leaving the machine, even if just for a few
seconds.
15
position for best performance.
AST
position.
LOW
position and
FF