Replacing The Fuses; Drive System Maintenance; Servicing The Tracks - Toro STX-26 Operator's Manual

Replacing the Fuses

There are 4 fuses in the electrical system. They are
under the control panel on the left side
Start circuit
Charge circuit
Cooler fan circuit
Headlight (optional)
Figure 40
1. Fuse block
Drive System
Maintenance
(Figure 40).
30 A

Servicing the Tracks

25 A
20 A
15 A
Cleaning the Tracks
Service Interval: Before each use or daily
Check the tracks for excessive wear and clean them
periodically. If the tracks are worn, replace them.
1.
2.
3.
Important:
water to wash only the track area. Do not use
a high-pressure washer to clean the rest of the
machine. High-pressure washing can damage the
electrical system and hydraulic valves or deplete
grease.
g013185
Important:
wheels and the drive wheel
wheels should rotate freely when clean.
1. Road wheels
2. Drive wheel
31
Park the machine on a level surface, engage the
parking brake, and lower the hydraulic lift.
Shut off the engine and remove the key.
Using a water hose or pressure washer, remove
dirt from each track system.
Ensure that you use high-pressure
Ensure that you fully clean the road
Figure 41
(Figure 41). The road
g013412
3. Track