Toro STX-26 Operator's Manual page 25

Changing the Engine Oil
Note:
Dispose of the used oil at a recycling center.
1. Start the engine and let it run for 5 minutes.
Note:
This warms the oil so that it drains better.
2. Park the machine on a level surface, engage
the parking brake (if applicable), and lower the
hydraulic lift.
3. Shut off the engine and remove the key.
4. Change the oil as shown in
Figure 29
5. Slowly pour approximately 80% of the specified
oil into the filler tube and slowly add the
additional oil to bring it to the Full mark
30).
(Figure 29).
g242255
g027734
(Figure
25
Figure 30
6. Start the engine and drive to a flat area.
7. Check the oil level again.
g194610